How will the steering shaft assembly be broken down?
发布时间：2017.01.17 新闻来源：邢台远拓汽车零部件制造有限公司
1) with pliers remove circlip for hole, gently and evenly using a copper percussion steering shaft with screw thread head, until the bearing outer ring bearing prolapse hole, taking the steering shaft with bearing assembly from the lower end of the support. Note Pratia struck the steering shaft thread head, should take protective measures to prevent the deformation of screw thread. 2) check the sliding fork assembly and the cardan fork assembly, whether the rotation is flexible, whether rust and hairpin, if one of the defects, is to break the cross shaft grease mouth assembly. (1) the elastic retainer ring with pointed nose pliers out of the hole at both ends of the cross shaft. (2) with a wooden hammer or Pratia as shown parts of percussion, to bring to the cross shaft and the bearing from the bearing hole. (3) bearings on another axis are also operated in directions and procedures. 4) take the bearings as shown. Note that the inspected parts are not damaged and are flexible enough to be removed without checking the bearings. 5) clean parts with clean gasoline and kerosene. Do not clean the seal rubber seal with gasoline, do not use steam or alkaline cleaning solution for cleaning bearing. Clean the parts with dry, clean compressed air after cleaning.
