Our company is committed to the research and innovation of transmission shaft hanger, and now with a number of automobile manufacturers, the establishment of a good supporting relationship. The following small to bring you drive shaft hanger base plane selection related information.

1. Selection of rough datum. For the general bracket parts, it is perfectly reasonable to use the relative surface of the bottom of the bracket as the rough datum. But for this part, if the bracket bottom surface opposite as a rough benchmark, it may cause the datum can not be guaranteed, therefore, in accordance with the principle of benchmark crude (i.e. when the parts are not processing surface, with these surface as rough basis; if there are a number of parts processing surface is not. Should be based on the relative position accuracy and machining surface requires high processing surface as a rough benchmark).

2, the choice of precision benchmark. The problem of datum coincidence is mainly considered. When the design standards and process standards do not coincide, the size conversion should be carried out, which will be calculated in the future, no longer repeat here.

The above information is the transmission shaft hanger base plane selection of relevant information, more information can be consulted to our company. The company is willing to sincerely cooperate with our customers with high quality products, reasonable prices, enthusiastic service, mutual benefit, and seek common development!